Ultimate EdiabasISTA+ voltage control V3

[Flying_Dutchman]

Installation instructions:

1. Go to Ediabas folder. For INPA its normaly C:\Ediabas\Bin, for ISTA+ its in Ediabas\Bin folder with ISTA+ directory.
1. If you are using STD:OBD rename existing obd32.dll to obd32.ebas.dll. Users of other cable types rename respective dll (for example STD:CAN users rename can32.dll to can32.ebas.dll).
2. Extract the downloaded file.
3. Copy included obd32.dll to Ediabas\Bin. For other cable types rename it to respective name first (for example can32.dll).
4. For ISTA+ only: copy included NodeISTAVoltageControl.dll to Ediabas\Bin folder within ISTA+ installation.
5. For ISTA+ v4.05 (and above) only:
a) replace existing IstaOperation.exe within ISTA+'s TesterGUI\Bin\Release folder by included one (from respective folder based on ISTA+ version).
b) run included AllowFakeISTAOperation.reg file (choose x86 or x64 depending on your system being 32 or 64 bit respectively).

To manually control the voltage start included NodeEdiabasVoltageControl.exe application. This application can be placed in a different folder if wanted. Voltage can be adjusted by moving sliders or switched off using check boxes. Unchecking check box has the same effect as moving slider to 0V.

UPDATE V3.0:

Version 3.0 of this tool has been released. New features:
1. Control application can now be minimized.
2. Support for ISTA+ v4.05 (and hopefully above).

System requirements: Visual Studio 2015 x86 runtime must be installed (same as required for last versions of ISTA+).

Section téléchargement, voir en bas de cette page
Download section, see bottom of this page

Télécharger-Download.txt